|
1.Remove the parts indicated in the figure, swivel the caliper body upward and retain it
with a wire or similar tool.
|
|
2.Remove the following parts from the caliper support.
(1)
Shim
(2)
Brake pad assembly
(3)
Clip
|
|
3.
| caution |
Keep grease or other soiling off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the cylinder using the special tool piston
expander (MB990520).
4.Assemble the shim, brake pad assembly and clip to the caliper support, and tighten
the guide pin to the specified torque.
Tightening torque: 44 ± 5 N·m
| note |
Install the brake pad assembly (with wear indicator) to the inner side of the brake disc,
making sure that the wear indicator is located on the top.
|
|
|
|
1.Remove the parking brake rear cable mounting bolts and nut (at the cable clamp) to
loosen the cable. (Refer to GROUP 36 - Parking Brake  ).
|
|
2.Remove the parts indicated in the figure, swivel the caliper body upward and retain it
with a wire or similar tool.
|
|
3.Remove the following parts from the caliper support.
(1)
Shim
(2)
Brake pad assembly (brake pad and wear indicator assembly)
(3)
Clip
|
|
4.
| caution |
Keep grease or other soiling off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the cylinder using the special tool piston
expander (MB991621).
|
|
5.Assemble the brake pad assembly to the caliper support, and tighten the guide pin to the
specified torque.
Tightening torque: 35 ± 4 N·m
| note |
Install the brake pad assembly (with wear indicator) to the inner side of the brake disc,
making sure that the wear indicator is located on the bottom.
|
6.Connect the parking brake rear cable.(Refer to GROUP 36 - Parking Brake ).
|
