Inspection Procedure A-1: The front fog lamps do not illuminate normally.



caution Whenever the ECU is replaced, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.

CIRCUIT OPERATION




  • Tail lamp switch
  • Headlamp switch
  • Fog lamp switch
  • Option coding information

COMMENTS ON TROUBLE SYMPTOM




PROBABLE CAUSES



  • Malfunction of column switch
  • Malfunction of the ETACS-ECU
  • Damaged harness wires and connectors

DIAGNOSIS PROCEDURE


STEP 1. ETACS-ECU coding data check


(1)Operate the M.U.T.-III to read the ETACS-ECU option coding information (Refer to GROUP 00 - Coding Table ).
(2)Check that the "Front fog lamp" is set to "Present."

Q. Is the check result normal?





STEP 2. Check the operation of the position lamps and the headlamps.



Q. Is the check result normal?





STEP 3. M.U.T.-III diagnosis code



Q. Is the diagnosis code set?





STEP 4. M.U.T.-III data list




  • Turn the front fog lamp switch to ON.
Item No.
Item name
Normal condition
Item 212
Front fog lamp
ON
OK: Normal condition is displayed.

Q. Is the check result normal?





STEP 5. Connector check: A-18X front fog lamp relay connector


Q. Is the check result normal?





STEP 6. Check the front fog lamp relay



Q. Is the check result normal?





STEP 7. Voltage measurement at the A-18X front fog lamp relay connector


(1)Remove the front fog lamp relay, and measure at the relay box side.
(2)Measure the voltage between terminal 2 and the body earth, and between terminal 4 and body earth.
OK: System voltage

Q. Is the check result normal?





STEP 8. Wiring harness check between the A-18X front fog lamp relay connector terminal No. 2/4 and the fusible link (36) <petrol> or (38) <diesel>



  • Check the output lines for open circuit.

Q. Is the check result normal?





STEP 9. Connector check: C-410 ETACS-ECU connector


Q. Is the check result normal?





STEP 10. Wiring harness check between the A-18X front fog lamp relay connector terminal No. 1 and the C-410 ETACS-ECU connector terminal No. 4



  • Check the output lines for open circuit.

Q. Is the check result normal?





STEP 11. Wiring harness check between the A-18X front fog lamp relay connector terminal No. 3 and the A-52 intermediate connector terminal No. 1



  • Check the output lines for open circuit.

Q. Is the check result normal?





STEP 12. Wiring harness check between the A-52 intermediate connector terminal No. 3 and the body earth



  • Check the earth lines for open circuit.

Q. Is the check result normal?





STEP 13. Retest the system



Q. Is the check result normal?