WHEEL BEARING FOR AXIAL PLAY CHECK
1.Remove the caliper assembly and the brake disc, then retain them using a wire or the like to prevent from falling (refer to  ). |
 |
2.Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the play. Limit value: 0.05 mm 3.If the limit value is exceeded, replace the wheel bearing (refer to ).4.After checking, install the brake disc and the caliper assembly, and tighten the caliper mounting bolt to the specified torque. Tightening torque: 100 ± 10 N·m |