BRAKE PAD REPLACEMENT


caution When replacing, replace both brake pad assembly (right and left) as a set.

1.Remove the pin bolt, and swivel the caliper body upward and retain it with a wire or similar tool.
2.

Remove the following components from the caliper support.
(1) Shim
(2) Brake pad assembly
(3) Clip

3.
caution Keep grease or other fouling off the brake pad assembly and brake disc friction surface.
Clean the piston, and press the piston into the cylinder using the special tool piston expander (MB990520).
4.Assemble the shim, brake pad assembly, and clip to the caliper support, then tighten the pin bolt to the specified torque.
Tightening torque : 27 ± 4 N·m