REMOVAL AND INSTALLATION



danger When servicing the high-voltage system parts, be sure to wear the specified protection equipment and disconnect the service plug to interrupt the high-voltage supply (Refer to ).
Pre-removal operation
  • Coolant draining (Refer to GROUP 14 - On-vehicle Service, Coolant Replacement .)

Post-installation operation
  • Coolant refilling (Refer to GROUP 14 - On-vehicle Service, Coolant Replacement .)





Removal steps
<<A>>

·
Radiator condenser tank (Refer to GROUP 14 - Water Hose and Water Pipe .)
<<B>>
>>A<<
1.
Radiator piping hose K connection
<<B>>
>>A<<
2.
Radiator piping hose L connection


3.
On board charger/DC-DC converter

REMOVAL SERVICE POINTS



<<A>> RADIATOR CONDENSER TANK REMOVAL


1.Remove the radiator condenser tank with hose attached from the on board charger/DC-DC converter.
2.Fix the removed radiator condenser tank at a position that does not interfere the removal and installation of the on board charger/DC-DC converter using a string or the equivalent.

<<B>> RADIATOR PIPING HOSE DISCONNECTION



Put a mating mark before removal as shown in the figure in order to assemble the hose and hose clips to the original positions.

INSTALLATION SERVICE POINTS



>>A<< RADIATOR PIPING HOSE CONNECTION


1.Insert the hose to each pipe up to the convex portion.
2.Align the mating marks on the hose and hose clips and install the hose without twisting the hose.