REMOVAL AND INSTALLATION



Pre-removal and post-installation operation
  • Discharging and Recharging refrigerant (Refer to )
  • Front bumper face removal and installation (Refer to GROUP 51 - Front Bumper Assembly .)
  • Air guide panel removal and installation (Refer to GROUP 51 - Front Bumper Assembly .)





Removal steps
<<A>>

1.
Stopper
<<B>>

2.
A/C condenser outlet pipe connection
<<B>>

3.
A/C condenser discharge hose


4.
O-ring


5.
Radiator support insulator


6.
Condenser header cap


7.
O-ring


8.
Dryer


9.
Condenser assembly

REMOVAL SERVICE POINTS



<<A>> STOPPER REMOVAL



Remove it using a flat-tipped screwdriver as shown in the figure.

<<B>> A/C CONDENSOR OUTLET PIPE /A/C CONDENSOR DISCHARGE HOSE CONNECTION


caution
  • Use the plug which is not breathable because A/C compressor oil or receiver have high hygroscopicity.
  • For the compressor oil and installation oil for the piping O-ring, use the oil MA68EV dedicated for the A/C compressor EV30AN3. If an oil other then the MA68EV is used, even if it is only a small amount, the electric insulation is considerably deteriorated and a leakage may occur.
Plug the removed nipple of the pipe, hose and condenser to prevent the entry of dust and dirt.