|
|
1.Drain the A/T fluid.
| note |
The hydraulic pressure test must be performed before attempting any adjustments.
|
|
|
|
2.Remove the valve body cover.
|
|
3.Turn the adjusting screw shown in the illustration to adjust the line pressure to the standard value. The pressure increases when the screw is turned anti-clockwise.
| note |
When adjusting the line pressure, adjust to the middle of the standard value range.
|
Standard value: 1.01 -
1.05 MPa (Change in pressure for a single full of the adjusting screw: 0.035 MPa)
4.Install the valve body cover, and then pour in the specified amount of A/T fluid.
5.Repeat the hydraulic pressure test (Refer to  .) Readjust the line pressure if necessary.
|