Code No.1005: P/W (DR) 3 Times jam-protection


caution Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

COMMENTS ON TROUBLE SYMPTOM


Current trouble
  • If the jam prevention function is operated 3 times or more in succession, ETACS-ECU sets the diagnosis code No. 1005.
Past trouble
  • If the diagnosis code No. 1005 is set as past trouble, carry out diagnosis with particular emphasis on wiring and connector(s) in the CAN bus line. For diagnosis procedures, refer to How to cope with past trouble (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Treat Past Trouble ).
    note For a past trouble, you cannot find it by the M.U.T.-III CAN bus diagnostics even if there is any failure in CAN bus lines. In this case, refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Treat Past Trouble and check the CAN bus lines. You can narrow down the possible cause of the trouble by referring to the diagnosis code, which is set regarding the CAN communication-linked ECUs (Refer to GROUP 54C - Explanation About The M.U.T.-III CAN Bus Diagnostics ).

PROBABLE CAUSES



  • Malfunction of the front power window motor <driver’s side>
  • Malfunction of the power window main switch

DIAGNOSIS PROCEDURE

STEP 1. Confirm the front power window <driver’s side> learning function.
(1)Check that the power window main switch has learned the fully closed position of the window (Refer to ).
(2)On completion, check that diagnosis code No.1005 is not reset.

Q. Is the check result normal?
The procedure is complete.
Go to Step 2.

STEP 2. Check whether the diagnosis code is reset.
(1)Replace the front power window motor <driver’s side>.
(2)Check that diagnosis code is not reset.

Q. Is diagnosis code set?
Replace the power window main switch.
The procedure is complete.