Code No.3008: P/W (RL) Parameter read fail
Code No.3009: P/W (RL) Position read fail

COMMENTS ON TROUBLE SYMPTOM

• At the engine startup, if a signal reception of the rear power window sub switch (LH) information fails, ETACS-ECU stores the diagnosis code No. 3008.
  
• At the engine startup, if a signal reception of the rear left door window glass position fails, ETACS-ECU sets the diagnosis code No. 3009.
  

• If the diagnosis code No. 3008 or 3009 is set as past trouble, carry out diagnosis with particular emphasis on wiring and connector(s) in the CAN bus line. For diagnosis procedures, refer to How to cope with past trouble (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Treat Past Trouble ).
  

  note

  For a past trouble, you cannot find it by the M.U.T.-III CAN bus diagnostics even if there is any failure in CAN bus lines. In this case, refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Treat Past Trouble and check the CAN bus lines. You can narrow down the possible cause of the trouble by referring to the diagnosis code, which is set regarding the CAN communication-linked ECUs (Refer to GROUP 54C - Explanation About The M.U.T.-III CAN Bus Diagnostics ).

PROBABLE CAUSES

• Malfunction of the rear power window sub switch (LH)
  

	Replace the rear power window sub switch (LH).

	The procedure is complete.