|
|
- Item 36: Variable geometry control solenoid valve
|
|
|
OK: The variable geometry actuator is operated
|
|
|
Q.
Is the check result normal?
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|

|
Q.
Is the check result normal?
Go to Step 3 .
Repair or replace the connector.
|

|
- Disconnect connector, and measure at solenoid valve side.
- Resistance between terminal No. 1 and No. 2.
OK: 10 - 14 Ω (at 20°C)
Q.
Is the check result normal?
Go to Step 4 .
Replace the variable geometry control solenoid valve.
|

|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal No. 2 and earth.
OK: System voltage
Q.
Is the check result normal?
Go to Step 6 .
Go to Step 5 .
|


|
Q.
Is the check result normal?

Check and repair harness between A-56 (terminal No.
2) variable geometry control solenoid valve connector and A-20X (terminal No. 3) engine control
relay connector.
- Check power supply line open/short circuit
Repair or replace the connector.
|

|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal No. 17 and earth.
OK: System voltage
Q.
Is the check result normal?
Go to Step 8 .
Go to Step 7 .
|


|
Q.
Is the check result normal?

Check and repair harness between A-56 (terminal No.
1) variable geometry control solenoid valve connector and C-105 (terminal No. 17) engine-ECU
connector.
- Check output line for open/short circuit.
Repair or replace the connector.
|

|
Q.
Is the check result normal?
Go to Step 9 .
Repair or replace the connector.
|


|
- Check output line for damage.
Q.
Is the check result normal?
Go to Step 10 .
Repair the damaged harness wire.
|


|
- Check power supply line for damage.
Q.
Is the check result normal?
Go to Step 11 .
Repair the damaged harness wire.
|
|
|
- Item 36: Variable geometry control solenoid valve
|
|
|
OK: The variable geometry actuator is operated
|
|
|
Q.
Is the check result normal?
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
|
|
Replace the engine-ECU. When the engine-ECU is replaced, write the chassis number
(Refer to GROUP 00 - Precautions Before Service - How to Perform Chassis Number
Writing ). After replacing the engine-ECU, register the injector
identification code and learn fuel injection (Refer to GROUP 00 - Precautions Before
Service - What The Common Rail Engine Learns ). After
registering the injector identification code, carry out the forcible DPF regeneration. (Refer
to GROUP 17 - Emission Control - Diesel Particulate Filter (DPF) System - Forcible
DPF Regeneration ).
|
|
|
|