|
|
Q.
Does an indicator other than the engine warning lamp illuminate?
|
|
|
Inspect combination meter and related circuits (Refer to GROUP 54A - Combination Meter - Check Chart for Trouble Symptoms ).
|
|
|
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Inspection chart for diagnosis code (Refer to ).
|
|
|
|


|
Q.
Are the check results normal?
Go to Step 4.
Repair or replace.
|


|
- Disconnect C-105 engine-ECU connector and C-111 combination meter connector, and measure resistance at the wiring harness.
- Resistance between C-105 engine-ECU connector terminal No. 46 and C-111 combination connector terminal No. 63.
OK: Continuity (2 Ω or less)
Q.
Is the check result normal?
Go to Step 5.
Check the intermediate connector C-53 <L. H. drive vehicles>, C-35 <R. H. drive vehicles>, and repair if necessary. If intermediate connector is normal, repair the harness wire.
|
|
|
Q.
Does trouble symptom persist?
|
|
|
Replace the engine-ECU. When the engine-ECU is replaced, write the chassis number (Refer to GROUP 00 - Precautions Before Service - How to Perform Chassis Number Writing ). After replacing the engine-ECU, register the injector identification code and learn fuel injection (Refer to GROUP 00 - Precautions Before Service - What The Common Rail Engine Learns ). After registering the injector identification code, the vehicle equipped with the DPF carries out the forcible DPF regeneration. (Refer to GROUP 17 - Emission Control - Diesel Particulate Filter (DPF) System - Forcible DPF Regeneration ).
|
|
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|