ENGINE COOLANT REPLACEMENT


warning When removing the radiator cap, use care to avoid contact with hot coolant or steam. Place a shop towel over the cap and turn the cap anti-clockwise a little to let the pressure escape through the vinyl tube. After relieving the steam pressure, remove the cap by slowly turning it anti-clockwise.
1.Drain the water from the radiator, heater core and engine after unplugging the radiator drain plug and removing the radiator cap.

2.Drain the water in the water jacket by disconnect the engine oil cooler water hose.
3.Remove the radiator condenser tank and drain the coolant.
4.Drain the coolant then clean the path of the coolant by injecting water into the radiator from the radiator cap area.
5.Connect the engine oil cooler water hose.
6.Securely tighten the drain plug of the radiator.
7.Reinstall the radiator condenser tank.

8.
caution Do not use alcohol or methanol anti-freeze or any engine coolants mixed with alcohol or methanol anti-freeze. The use of an improper anti-freeze can cause corrosion of the aluminium components.
By referring to the section on coolant, select an appropriate concentration for safe operating temperature within the range of 30 to 60%. Use special tool LLC changer (MB991871) to refill the coolant. A convenient mixture is a 50% water and 50% antifreeze solution (freezing point: -31°C).

    Recommended antifreeze: MITSUBISHI MOTORS GENUINE SUPER LONG LIFE COOLANT or equivalent
    Quantity: 8.2 L
note For how to use special tool MB991871, refer to its manufacturer’s instructions.
9.Reinstall the radiator cap.
10.Start the engine and let it warm up until the thermostat opens.
11.After repeatedly revving the engine up to 3,000 r/min several times, then stop the engine.
12.Remove the radiator cap after the engine has become cold, and pour in coolant up to the brim. Reinstall the cap.
13.
caution Do not overfill the radiator condenser tank.
Add coolant to the radiator condenser tank between the "F" and "L" mark if necessary.