REMOVAL AND INSTALLATION


note The ABS-ECU is integrated in the hydraulic unit.
Pre-removal Operation
  • Brake Fluid Draining

 Post-installation Operation
  • Brake Fluid Filling
  • Brake Line Bleeding (Refer to GROUP 35A, On-vehicle Service - Bleeding .)
  • Hydraulic Unit Check (Refer to .)




Removal steps


1.
 Harness connector

>>A<<
 2.
 Brake pipe and hydraulic unit assembly connection


3.
 Brake pipe and master cylinder connection <RHD>


4.
 Brake pipe <RHD>


5.
 Hydraulic unit assembly and hydraulic unit bracket assembly


6.
 Insulator


7.
 Collar
<<A>>
8.
 Hydraulic unit assembly (integrated with ABS-ECU)


9.
 Hydraulic unit bracket assembly

REMOVAL SERVICE POINT

<<A>> HYDRAULIC UNIT ASSEMBLY (INTEGRATED WITH ABS-ECU) REMOVAL
warning The hydraulic unit is heavy. Use care when removing it.
caution
  • The hydraulic unit cannot be disassembled. Never loosen its nuts or bolts.

  • Do not drop or shock the hydraulic unit.

  • Do not turn the hydraulic unit upside down or lay it on its side.

INSTALLATION SERVICE POINT

>>A<< BRAKE PIPE AND HYDRAULIC UNIT CONNECTION

Connect the pipes to the hydraulic unit assembly as shown in the illustration.
1.From the master cylinder (primary)
2.To the front brake (LH)
3.To the rear brake (RH)
4.To the rear brake (LH)
5.To the front brake (RH)
6.From the master cylinder (secondary)