Code No.C1364: Pressure sensor malfunction


caution If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Diagnose the CAN bus lines before the diagnosis codes (Refer to GROUP 54C - CAN Bus Diagnostics Table ).

OPERATION
ASTC-ECU monitors the fluid pressure in the hydraulic unit using the incorporated pressure sensor, and adjusts the fluid pressure for the ASC or ATC drive based on this data.

DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when the vehicle speed is 10 km/h or more and the output value of the pressure sensor is more than the specified value.

PROBABLE CAUSES
The most likely causes for these diagnosis codes to set are:

  • Damaged wiring harness or connector
  • Malfunction of the hydraulic unit assembly (integrated with ASTC-ECU)

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnostics.
Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result?
Go to Step 3.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ). Then go to Step 2.

STEP 2. Check whether the diagnosis code is reset.
(1)Turn the ignition switch to the "ON" position.
(2)Erase the diagnosis code.
(3)Turn the ignition switch to the "LOCK" (OFF) position.
(4)Turn the ignition switch to the "ON" position.
(5)Check if the diagnosis code is set.
(6)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is code No.C1364 set?
Go to Step 3.
The procedure is complete.

STEP 3. Check whether the diagnosis code is reset.
(1)Turn the ignition switch to the "ON" position.
(2)Erase the diagnosis code.
(3)Turn the ignition switch to the "LOCK" (OFF) position.
(4)Turn the ignition switch to the "ON" position.
(5)Check if the diagnosis code is set.
(6)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is code No.C1364 set?
Replace the hydraulic unit assembly (integrated with ASTC-ECU). (Refer to ). Then go to Step 4.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction .)

STEP 4. Check whether the diagnosis code is reset.
(1)Turn the ignition switch to the "ON" position.
(2)Erase the diagnosis code.
(3)Turn the ignition switch to the "LOCK" (OFF) position.
(4)Turn the ignition switch to the "ON" position.
(5)Check if the diagnosis code is set.
(6)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is code No.C1364 set?
Go to Step 1.
The procedure is complete.