Inspection Procedure A-4: Selector "P" position-linked door unlock function does not operate normally. <Vehicles with automatic transmission with keyless entry system>



caution Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.





COMMENT ON TROUBLE SYMPTOM


If the doors are not unlocked when the selector lever is shifted to the "P" position, the shift position signal input circuit(s) or the ETACS-ECU may be defective. Also, the function to interlock the shift P position with door unlocking may have been disabled with a customise function.

POSSIBLE CAUSES



  • Malfunction of the ETACS-ECU
  • Damaged harness wires and connectors

DIAGNOSIS PROCEDURE


STEP 1. Checking central door unlocking operation


Check that the central door locking system works normally.

Q. Is the check result normal?

Go to Step 2.
Refer to .

STEP 2. Customise function by using the M.U.T.-III


Use the M.U.T.-III to confirm that the following other than "Inhibit" is set to the customise function.

  • Operation

Q. Is the check result normal?

Go to Step 3.
Use the M.U.T.-III customise function to set "Operation" (Refer to ).

STEP 3. M.U.T.-III CAN bus diagnostics


Using the M.U.T.-III, diagnose the CAN bus lines.

Q. Is the CAN bus normal?

Go to Step 4.
Correct the CAN bus line (Refer to GROUP 54C, Troubleshooting ).

STEP 4. M.U.T.-III other system diagnosis code


Check whether the A/T-ECU-related diagnosis code is set.

Q. Is the diagnosis code set?

Diagnose the A/T (Refer to GROUP 23A, Troubleshooting ).
Go to Step 5.

STEP 5. Retest the system.


Check that shifting the selector lever to the P position unlocks the doors.

Q. Is the check result normal?

The trouble can be an intermittent malfunction (Refer to GROUP 00, How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU and register the ID codes (Refer to GROUP 54A, How to Register Encrypted Code ).