


|
1.Measure the centre of the front fog lamps, as shown in the illustration. 2.Set the distance between the screen and the centre of the front fog lamps as shown
in the illustration. 3.Inflate the tyres to the specified pressures and there should be no other load in
the vehicles other than driver or substituted weight of approximately 75 kg placed in the driver’s
position. 4.With the engine running at 2,000 r/min, aim the front fog lamp. 5.Remove the fog lamp bezel. (Refer to .)
|


|
6.Insert a Phillips screwdriver into the service hole and place it on the adjusting screw.
|

|
7.Adjust the cut off line (boundary between light and dark) position to the standard value
with the adjusting screw. Standard value: (Vertical direction) 60 mm (1.15°) below horizontal (H)
| note |
The horizontal direction is non-adjustable. If the deviation of the light beam axis exceeds
the standard value, check to be sure that the mounting location or some other point is not defective.
|
|