REMOVAL AND INSTALLATION <BWC>

			Exhaust main muffler removal steps
		1.	Exhaust main muffler
		5.	Gasket
		6.	Exhaust muffler hanger
			Centre exhaust pipe and front floor panel rear heat protector removal steps
		2.	Backbone brace
		3.	Centre exhaust pipe
		5.	Gasket
		7.	Exhaust pipe gasket
		8.	Exhaust muffler hanger
<<A>>	>>A<<	9.	Rivet
		10.	Front floor panel rear heat protector
			Front exhaust pipe and front floor panel front heat protector removal steps
		4.	Front exhaust pipe
		7.	Exhaust pipe gasket
		11.	Gasket
		12.	Dash panel heat protector
<<A>>	>>A<<	13.	Rivet
		14.	Front floor panel front heat protector

REMOVAL SERVICE POINT

<<A>> RIVET REMOVAL

caution

Be careful not to damage the heat protector with the drill.

Use a drill (6.0 mm) to make a hole in the rivet to break it, and then remove the rivet.

INSTALLATION SERVICE POINT

>>A<< RIVET INSTALLATION

Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the part is fixed in position.