|
|
1.Remove the cruise control switch (Refer to  ) <4B10> or (Refer to ) <4B11-Turbo>.
|
|
2.Measure the resistance between terminal No.2 and terminal No.3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
|
|
Terminal connector of tester
|
Switch position
|
Specified condition
|
2 - 3
|
All switches are released.
|
Open circuit
|
"ON/OFF" switch is pressed
|
Continuity (less than 2 ohms)
|
"CANCEL" switch is pressed
|
202.5 - 208 Ω
|
"COAST/SET" switch is pressed
|
610.5 - 624.5 Ω
|
"ACC/RES" switch is pressed
|
1838 - 1877 Ω
|
|
3.Check for continuity between the terminal No.1 and terminal No.4 of the cruise control switch.
|
|
Terminal connector of tester
|
Specified condition
|
1 - 4
|
Continuity
|
|
|
|
|
1.Disconnect the stop lamp switch harness connector.
|
|
2.Check for continuity between the terminals of the switch.
|
|
Measurement condition
|
Terminal connector of tester
|
Specified condition
|
When brake pedal is depressed.
|
1 - 2 (for stop lamp switch)
|
Continuity (less than 2 Ω)
|
3 - 4 (for brake switch)
|
Open circuit
|
When brake pedal is not depressed.
|
1 - 2 (for stop lamp switch)
|
Open circuit
|
3 - 4 (for brake switch)
|
Continuity (less than 2 Ω)
|
|
|
|
|
1.Disconnect the clutch switch harness connector.
|
|
2.Check for continuity between the terminals of the switch.
|
|
Measurement condition
|
Terminal connector of tester
|
Specified condition
|
When clutch pedal is depressed.
|
1 - 2
|
Continuity (less than 2 Ω)
|
When clutch pedal is not depressed.
|
1 - 2
|
Open circuit
|
|
|
|
|
Refer to GROUP 23A - On-vehicle Service, Essential Service, Inhibitor Switch Continuity Check .
|
|
|
Refer to GROUP 13B - On-vehicle Service, Throttle Valve Control Servo Check <4B10>.
|
|
|
Refer to GROUP 13C - On-vehicle Service, Throttle Valve Control Servo Check <4B11-Turbo>.
|