Item No.
|
Check item
|
Check condition
|
Normal condition
|
04
|
Vehicle speed signal
|
Road test the vehicle.
|
The speedometer and M.U.T.-III display the same value.
|
11
|
Accelerator pedal position sensor (main)
|
Ignition switch: ON
|
Accelerator pedal: Released
|
900 - 1,100 mV
|
Accelerator pedal: Depressed
|
Increases in response to the pedal depression stroke.
|
Accelerator pedal: Fully depressed
|
4,000 mV or more
|
13
|
Throttle position sensor (main)* <4B10>
|
- Remove the air cleaner to throttle body duct at the throttle body side.
- Disconnect the throttle position sensor connector, and then connect terminal No. 3, 4, 5 and 6 with the use of the special tool test harness (MB991658).
- Ignition switch: ON (engine stopped)
|
Fully close the throttle valve with your finger.
|
300 - 700 mV
|
Fully open the throttle valve with your finger.
|
4,000 - 4,800 mV
|
- Set the vehicle to the pre-inspection condition
- Engine: Idle operation
|
No load
|
500 - 660 mV
|
A/C switch: OFF → ON
|
Voltage rises.
|
Selector lever: "N" → "D"
|
13
|
Throttle position sensor (main)* <4B11-Turbo>
|
- Remove the intercooler outlet air hose E at the throttle body side.
- Disconnect the throttle position sensor connector, and then connect terminal No. 3, 4, 5 and 6 with the use of the special tool test harness (MB991658).
- Ignition switch: ON (engine stopped)
|
Fully close the throttle valve with your finger.
|
300 - 700 mV
|
Fully open the throttle valve with your finger.
|
4,000 mV or more
|
Engine: Idle operation after warm-up
|
No load
|
500 - 700 mV
|
A/C switch: OFF → ON
|
Voltage rises.
|
Shift lever: "N" → "D"
|
57
|
Cancel code
|
Ignition switch: "ON"
|
The cancel code, which set when the cruise control system was cancelled at the last time, is set again.
|
74
|
Stop lamp switch (for stop lamp circuit)
|
Brake pedal: Depressed
|
ON
|
Brake pedal: Released
|
OFF
|
75
|
Cruise control switch
|
CANCEL
|
"CANCEL" switch: Pressed
|
ON
|
"CANCEL" switch: Released
|
OFF
|
78
|
Clutch switch <4B10-M/T>
|
Clutch pedal: Depressed
|
ON
|
Clutch pedal: Released
|
OFF
|
81
|
Cruise control operation
|
Cruise control: active
|
ON
|
Cruise control: Inactive
|
OFF
|
86
|
Cruise control switch
|
ON/OFF
|
"ON/OFF" switch: Pressed
|
ON
|
"ON/OFF" switch: Pressed again
|
OFF
|
88
|
Inhibitor switch <4B10-CVT> or Neutral switch <4B11-Turbo>
|
Selector lever or shift lever: "N", "R" or "P" position
|
ON
|
Selector lever or shift lever: Other than "N", "R" or "P" position
|
OFF
|
89
|
Brake switch (for cruise control circuit)
|
Brake pedal: Depressed
|
ON
|
Brake pedal: Released
|
OFF
|
91
|
Cruise control switch
|
ACCELERATING/RESUME
|
"ACC/RES" switch: Pressed
|
ON
|
"ACC/RES" switch: Released
|
OFF
|
92
|
Cruise control switch
|
COAST/SET
|
"COAST/SET" switch: Pressed
|
ON
|
"COAST/SET" switch: Released
|
OFF
|
) <4B10> or (Refer to GROUP 13C - Diagnostic Function