DISASSEMBLY AND REASSEMBLY



Disassembly steps


1.
 Oil separator


2.
 Tapered roller bearing outer race


3.
 Shim kit


4.
 Oil seal


5.
 Tapered roller bearing outer race


6.
 Shim kit


7.
 Hole snap ring


8.
 Hole snap ring


9.
 Oil receiver pipe

DISASSEMBLY

1.Remove the oil separator.

2.Using special tools, remove the tapered roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

3.Remove the shim kit.

4.Remove the oil seal.

5.Using special tools, remove the tapered roller bearing outer race and shim kit.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

6.Remove the hole snap ring (two pieces).

7.Remove the oil receiver pipe.

REASSEMBLY

1.install the oil receiver pipe in the transmission case.

2.install the hole snap ring (two pieces) in the transmission case.

3.install the shim kit in the transmission case.

4.Using special tool, Bearing outer race installer (MB991966), install the tapered roller bearing outer race in the transmission case.

5.Using special tool, Differential oil seal installer (MB991168), install the oil seal in the transmission case.

6.Install the shim kit in the transmission case.

7.Using special tools, install the tapered roller bearing outer race in the transmission case.

  • Installer bar (MB990938)
  • Knuckle oil seal installer (MB991015)

8.Install the oil separator and tighten to the specified torque of 8.5 ± 2.5 N·m.