TRANSMISSION OIL CHANGE


1.Remove the engine room under cover front B assembly. (Refer to GROUP 51 - Under Cover .)

2.Remove the oil drain plug to drain the oil.
note Because the oil in the oil cooler and oil filter cannot be drained, the amount of drained oil will be approximately 5.5 L.
3.Tighten the oil drain plug to the specified torque.
Tightening torque: 35 ± 5 N·m
4.Remove the air cleaner element, air cleaner intake duct, and air cleaner body. (Refer to GROUP 15 - Air Cleaner .)

5.Remove the oil filler plug, then fill the oil.
Brand name: Dia Queen SSTF-I
Filling amount: Approximately 5.5 L
6.Tighten the oil filler plug to the specified torque.
Tightening torque: 35 ± 5 N·m
7.Install the air cleaner element, air cleaner intake duct, and air cleaner body. (Refer to GROUP 15 - Air Cleaner .)
8.Start the engine, then let it idle for 1 to 2 minutes.
9.Move the shift lever to every position, and then move it to the P or N range.
10.Stop the engine, then perform Steps 2 to 5 again.
11.Check the oil level and oil fouling. (Refer to .) If fouling is found, repeat Steps 2 to 5 until the fouling is eliminated.
12.Install the engine room under cover front B assembly. (Refer to GROUP 51 - Under Cover .)