
|
Use the special tools to remove the snap ring.
- Spring compressor (MD998907)
- Spring compressor retainer (MD998924)
|

|
Apply ATF, blue petrolatum jelly or white vaseline to the D-rings and handle them carefully
not to damage them during installation.
|

|
Use the special tools to install the snap ring.
- Spring compressor (MD998907)
- Spring compressor retainer (MD998924)
|

|
1.
| caution |
Soak the clutch discs in ATF before assembling it.
|
Assemble the clutch plates, clutch discs, and clutch reaction plates with their non-toothed
portions (A in the drawing) aligned with the hole (B in the drawing) formed in a crest of the
underdrive clutch retainer.
|

|
2.Orient the clutch reaction plate as shown in the drawing when it is installed.
|
|
|
2.Press down the clutch reaction plate on its entire circumference using the special
tools.
- Spring compressor (MB991628)
- Spring compressor retainer (MD998924)
|

|
3.Check the clearance between the snap ring and clutch reaction plate. If the clearance
is not within the standard value range, make adjustment by selecting a snap ring of an appropriate
thickness. Standard value: 1.2 - 1.4 mm (For underdrive clutch piston end play)
|