REMOVAL AND INSTALLATION <EXCEPT RALLIART>


Post-installation Operation
  • Parking Brake Lever Stroke Adjustment (Refer to ).
  • Parking Brake Lining Seating Procedure (Refer to ).




Removal steps


·
 Release the parking brake lever.


1.
 Plug
<<A>>
2.
 Rear brake caliper assembly


3.
 Rear brake disc

>>D<<
 4.
 Shoe-to-anchor spring

>>D<<
 5.
 Shoe-to-anchor spring


6.
 Shoe guide plate


7.
 Adjusting wheel spring

>>C<<
 8.
 Adjuster assembly


9.
 Strut


10.
 Strut shoe-to-spring


11.
 Shoe hold down pin


12.
 Shoe hold down cup


13.
 Shoe hold down spring


14.
 Shoe and lining assembly


15.
 Parking brake rear cable connection


16.
 Shoe and lever assembly
<<B>>
 >>B<<
 17.
 Retainer

>>A<<
 18.
 Wave washer


19.
 Parking lever


20.
 Shoe and lining assembly

REMOVAL SERVICE POINTS

<<A>> REAR BRAKE CALLIPER ASSEMBLY REMOVAL
1. Remove the rear brake caliper assembly with the brake hose.
2.Secure the removed rear brake caliper assembly with a wire or other similar material at a position where it will not interfere with the removal and installation operations.

<<B>> RETAINER REMOVAL

Use a flat-tipped screwdriver or a similar tool to open up the retainer joint. Then remove the retainer.

INSTALLATION SERVICE POINTS

>>A<< WAVE WASHER INSTALLATION

Install the wave washer in the direction shown in the illustration.

>>B<< RETAINER INSTALLATION

Use pliers or a similar tool to close the retainer end onto the pin.

>>C<< ADJUSTER ASSEMBLY INSTALLATION

Install the adjuster assemblies. The shoe adjusting bolt should be mounted to the rear of the vehicle for the right wheel, and to the front of the vehicle for the left wheel.

>>D<< SHOE-TO-ANCHOR SPRING INSTALLATION

The shoe-to-anchor springs are not interchangeable because their spring loads are different. The one with blue paint mark should be installed to the front of the vehicle, and the other with yellow paint to the rear of the vehicle, respectively.