INSPECTION PROCEDURE 1: Rear wiper does not work at all.











caution Whenever ECU is replaced, ensure that the input and output signal circuits are normal.


OPERATION


The ETACS-ECU operates the rear wiper in accordance with the input signals below.

  • Ignition switch (ACC)
  • Rear wiper switch

COMMENTS ON TROUBLE SYMPTOM


If the rear wiper does not work normally, the input signal circuits from the ignition switch (ACC), the column switch (column-ECU), the rear wiper motor or ETACS-ECU may be defective.

PROBABLE CAUSES



  • Defective rear wiper motor
  • Defective column switch (column-ECU)
  • Malfunction of ETACS-ECU
  • Malfunctions of the wiring harness and connectors

DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III diagnosis code


Check if an ETACS-related diagnosis code is set.

Q. Is the diagnosis code set?

Troubleshoot the ETACS. Refer to .
Go to Step 2.

STEP 2. M.U.T.-III data list


Check the input signal related to the rear wiper operation.

  • Turn the ignition switch to the ACC position.
Item No.
Item name
Normal conditions
Item 288
ACC switch
ON
OK: Normal condition is displayed.

Q. Is the check result normal?

Go to Step 3.
Refer to GROUP 54A - ETACS, Inspection Procedure 1 "The ignition switch (ACC) signal is not received ."

STEP 3. Check the F-41 rear wiper motor connector


Q. Is the check result normal?


    Go to Step 4.
Repair the defective connector.

STEP 4. Check the rear wiper motor.


Refer to GROUP 51 - Rear Wiper and Washer .

Q. Is the rear wiper motor normal?

Go to Step 5.
Replace the rear wiper motor.

STEP 5. Measure the resistance at the F-41 rear wiper motor connector.


(1)Disconnect the connector, and measure the resistance at the wiring harness.
(2)Measure the resistance between F-41 rear wiper motor connector terminal No. 3 and body earth.
OK: Continuity (2Ω or less)

Q. Is the check result normal?

Go to Step 7.
Go to Step 6.

STEP 6. Check the wiring harness between F-41 rear wiper motor connector terminal No. 3 and body earth.



  • Check the earth wires for open circuit.

Q. Is the check result normal?


    Go to Step 7.
Repair the wiring harness.

STEP 7. Check the C-311 ETACS-ECU connector


Q. Is the check result normal?

Go to Step 8.
Repair the defective connector.

STEP 8. Check the wiring harness wires between F-41 rear wiper motor connector terminal No. 1 and C-311 ETACS-ECU connector terminal No. 5.


note Prior to the wiring harness inspection, check intermediate connector D-17,F-40, and repair if necessary.

  • Check the power supply line for open or short circuit.

Q. Is the check result normal?

Go to Step 9.
Repair the wiring harness.

D-17STEP 9. Retest the system.


Check that the rear wiper works normally.

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.