DISASSEMBLY AND REASSEMBLY <1500>



Disassembly steps for refrigerant temperature switch


1.
 Snap ring


2.
 Connector bracket


3.
 Refrigerant temperature switch



Disassembly steps for magnetic clutch

>>D<<
 ·
 Air gap adjustment
<<A>>
 >>C<<
 4.
 Self-locking nut


5.
 Armature

>>B<<
 6.
 Snap ring


7.
 Rotor


8.
 Snap ring

>>A<<
 9.
 A/C compressor coil


10.
 Shim


11.
 A/C compressor

DISASSEMBLY SERVICE POINT

<<A>> SELF-LOCKING NUT REMOVAL

Use the special tools below to remove the self-locking nut.

  • Special spanner (MB991367)
  • Pin (MB991386)

ASSEMBLY SERVICE POINTS

>>A<< A/C COMPRESSOR COIL INSTALLATION

Install the A/C compressor coil while aligning the pin hole of A/C compressor itself with the protrusion of A/C compressor coil

>>B<< SNAP RING INSTALLATION

Use snap ring pliers to install the snap ring so that the taper faces outwards.

>>C<< SELF-LOCKING NUT INSTALLATION
Use the special tool as during removal to secure the armature and tighten the self-locking nut.

>>D<< AIR GAP ADJUSTMENT

Check that the air gap of clutch satisfies the standard value. If not within the standard value, use shims to adjust it.
Standard value: 0.25 - 0.5 mm