|
|
When the diesel particulate filter (DPF) is replaced, use M.U.T-III to reset the data
which the engine-ECU stores such as the travel distance, the amount of PM accumulated in the
DPF and the amount of the additive or cerium.
The data, therefore, must be reset according to the following procedures:
|


|
1.After the ignition switch is in "LOCK" (OFF) position, connect the M.U.T.-III to the
diagnosis connector. 2.Turn the ignition switch to "ON" position (But do not start the engine). 3.Select SPECIAL FUNCTION from the function menu on MPI/GDI/DIESEL display. 4.Select RESET from the SPECIAL FUNCTION menu. 5.Select the following item from the RESET menu to reset the data.
6.Select the following item from the RESET menu to reset the data.
- No. 11 DPF accumulation value
|