|
|
1.Check for oil leak from seal, and replace it if leak is detected.
|
|
|
2.Check for wear or damage at the top of the rod. Replace it, if required.
|
|
1.
| caution |
- Always use the vertical press and put the timing belt auto-tensioner vertically.
- Do not apply the load of 5,000 N or more to the rod.
- Do not press the rod beyond dimension "A" shown in the illustration.
|
Set the timing belt auto-tensioner as shown in the illustration.
2.Press the rod slowly down to the lowest point "A" shown in the illustration.
3.Repeat the procedure 2 three times.
4.While the rod is projected at the point "B" shown in the illustration, push the rod with 100 - 200 N. Check the enough stiffness. If the stiffness is not enough, replace the timing belt auto-tensioner.
5.Press down the rod slowly. Put the pin through the hole and secure it.
|