
|
| caution |
- Do not allow sealant to
squeeze out to the screw tip.
- Do not tighten, exceeding the specified torque.
|
1.Completely remove sealant adhering to the oil pressure switch and cylinder block threaded
holes. 2.Apply sealant of 5 mm to the threaded portion of the oil pressure switch shown in
the illustration. Specified sealant:
Three bond 1104, Three bond 1212, Three bond 1215 or equivalent
3.Tighten the oil pressure switch to the cylinder block to the specified torque of 10 ± 2
N·m.
|

|
Tighten the Alternator bracket to the specified torque of 44 ± 8 N·m.
| note |
Be careful to install mounting bolts because they are different in length.
|
|
|
|
Install the inlet manifold and temporarily tighten bolts.
|

|
Make sure that the inlet manifold stay is in intimate contact with the inlet manifold
and cylinder block boss before tightening it to the specified torque of 20 ± 2 N·m.
|
|
|
1.Apply gasoline to the O-ring.
|

|
2.When inserting an O-ring into the injector on the injection nozzle side, use special tool
O-ring installer (MB992106) to gradually expand the O-ring, and fit it in place.
|
|
|
1.
| caution |
Do not allow gasoline to enter the delivery pipe.
|
Apply gasoline to the O-ring of the injector.
|
|
|
2.Insert the injector into the delivery pipe while rotating the injector from side to
side, taking care not to damage the O-ring.
|
|
|
3.Check that the injector rotates smoothly. If it does not rotate smoothly, the O-ring
may be caught. Remove the injector and check the O-ring for damage. Then, insert it again into the
delivery pipe and check.
|

|
4.Make sure that the protrusion of the injector is at the centre as shown in the illustration.
|

|
5.Securely assemble the injector to the injector groove and delivery pipe collar.
|

|
1.Install the delivery pipe assembly, bracket and injector protector rear on the cylinder
head. 2.Tighten mounting bolts together with temporarily tightened inlet manifold mounting
bolts in the order shown in the illustration. 3.Tighten the delivery pipe assembly, bracket, injector protector rear and inlet manifold
in the order shown in the illustration to the specified torque of 20 ± 2 N·m.
|