INJECTOR CHECK



CHECK THE OPERATION SOUND



1.
caution Beware that, even if the injector to be checked is not operating, the operation sound of other injectors may be heard.
Use a stethoscope to listen to the operation sound (ticks) from the injectors while the engine is idling or cranking.
2.Verify that the operation sound increases with the higher engine speed.
note If the operating sound cannot be heard, inspect the injector actuation circuit.

MEASUREMENT OF RESISTANCE BETWEEN TERMINALS



Right bank side (No. 1, 3, 5 injector)



1.Disconnect the intermediate connector.
2.Measure the resistance between the injector intermediate connector terminals.
INJECTOR No.
MEASUREMENT TERMINAL
RESISTANCE
No. 1
6 - 7
10.5 - 13.5 Ω (at 20°C)
No. 3
6 - 8
No. 5
6 - 9
3.Connect the injector intermediate connector.

Left bank side (No. 2, 4, 6 injector)


1.Disconnect the injector connector.
2.Measure the resistance between terminals.
Standard value: 10.5 - 13.5 Ω (at 20°C)
3.If the resistance is deviates from the standard value, replace the injector.

CHECK THE INJECTION CONDITION


1.Release the residual pressure in the fuel pipe line to prevent the fuel from running out (Refer to ).
2.
caution Cover the hose connection with rags to prevent splash of fuel that could be caused by some residual pressure in the fuel pipe line.
Disconnect the high-pressure fuel hose at the delivery pipe side.
3.Remove the injector.


4.Prepare the special tool called injector test set (MB992076) as shown in the figure.
(1) Disconnect the injector mounting hose.
(2) Remove the adapter for mounting injector and attach the special tool Injector test nipple (MB992088) instead.
(3) After attaching the injector on the special tool Injector test nipple (MB992088), secure it with the special tool injector holder (MB991976 or MB992184).
5.Mount the injector test set (MB992076) prepared with the special tool hose adapter (MB992001) onto the high-pressure fuel hose.
6.Connect the M.U.T.-III to the diagnosis connector.
7.Turn the ignition switch to the ON position. (But do not start the engine.)
8.Select "Item No. 09" of the M.U.T.-III actuator test to drive the fuel pump.

9.Connect the special tool Injector test harness (MB991607) between the injector and battery to drive the injector.
10.Check each injector for spray conditions.The condition can be considered satisfactory unless it is extremely poor.
11.Stop the actuation of the injector, and check for leakage from the injector nozzle.
Standard value: 1 drop or less per minute
12.After turning the ignition switch to the "LOCK" (OFF) position, remove the M.U.T.-III.
13.Actuate the injector until it does not spray fuel any longer, then drain the fuel inside the special tool.
14.Remove the special tool.
15.When the spray condition is extremely poor or any fuel leaks from the injector nozzle, replace the injector.
16.Replace the injector and high-pressure fuel hose in the original places.