ACTUATOR TEST REFERENCE TABLE
| Item No. |
Inspection Item |
Drive content |
Inspection condition |
Normal condition |
Code No. or inspection procedure No. |
Reference page |
|
| 1 |
Injector |
Cut off No. 1 injector |
Engine: After warm-up, idle operation
(Cut off injectors sequentially to check for a cylinder that does not change engine in idle
status) |
Engine is changed (becomes unstable or stalled) |
Code No. P0201 |
 |
|
| 2 |
Cut off No. 2 injector |
Code No. P0202 |
|
||||
| 3 |
Cut off No. 3 injector |
Code No. P0203 |
|
||||
| 4 |
Cut off No. 4 injector |
Code No. P0204 |
|
||||
| 9 |
Fuel pump |
Drive fuel pump to circulate fuel |
|
Operating noise audible |
Procedure No. 20 |
|
|
| 10 |
Purge control solenoid valve |
Switch solenoid valve from OFF to ON |
Ignition switch: ON |
When the valve is actuated, operating noise is audible |
Code No. P0443 |
|
|
| 14 |
Cooling fan motor |
Actuate the fan motor |
Ignition switch: ON |
Fan motor rotates at high speed |
- |
- |
|
| 16 |
A/C compressor relay |
Switch the A/C compressor relay from OFF to ON |
Ignition switch: ON |
The operating sound of A/C compressor is audible |
Procedure No. 21 |
|
|
| 17 |
Intake oil feeder control valve, exhaust oil feeder control valve |
Switch the Intake oil feeder control valve and exhaust oil feeder
control valve from OFF to ON |
Ignition switch: ON |
When the valve is actuated, operating noise is audible |
Code No. P1021, P1025 |
, |
|