TURBOCHARGER SUPERCHARGING PRESSURE CHECK <4HN>


1.Disconnect the intake air pressure sensor connector.

2.Remove the intake air pressure sensor.


3.At the position where the intake air pressure sensor is removed, install the side "a" of special tool air press test harness (MB996202).
4.Install the intake air pressure sensor to the side "b" of special tool air press test harness (MB996202).

5.Install the pressure gauge to the side "c" of special tool air press test harness (MB996202).
6.Connect the connector of intake air pressure sensor.

7.Place the pressure gauge on the cup-holder

8.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III to the diagnosis connector.
9.Start the engine
10.Select item No. 113 (data list) on the M.U.T.-III.
11.Measure the boost pressure or absolute pressure with the accelerator fully opened.
Standard value: 110 - 160 kPa
12.Compare the absolute pressure values read on the M.U.T.-III and on the pressure gauge
note If there is a significant difference in the pressure read on the M.U.T.-III and on the pressure gauge, replace the intake air pressure sensor.
note In case of the gauge which uses the gauge pressure measurements, the reading equals the difference between the local absolute pressure and the local atmospheric pressure. Add the gauge pressure to the atmospheric pressure to get absolute pressure: Absolute pressure = gauge pressure + atmospheric pressure
13.If the supercharging pressure deviates from the standard value, check the following items for possible cause.

  • The turbocharger inlet and outlet air pipes
  • The turbocharger intercooler inlet and outlet air ducts
  • The turbocharger intercooler
  • The turbocharger

    When the boost pressure is 160kPa or more, the boost pressure control might be abnormal. Check on the boost pressure control system.