REMOVAL AND INSTALLATION <BSY>







Exhaust main muffler and rear floor panel heat protector removal steps


1.
Exhaust main muffler


3.
Exhaust pipe gasket


9.
Exhaust muffler hanger


10.
Rear floor panel heat protector



Centre exhaust pipe and front floor panel heat protector removal steps


2.
Centre exhaust pipe


3.
Exhaust pipe gasket


6.
Exhaust pipe gasket


7.
Exhaust muffler hanger
<<A>>
>>A<<
8.
Rivet


11.
Front floor panel heat protector



Catalytic converter assembly removal steps


4.
Catalytic converter assembly


5.
Seal ring


6.
Exhaust pipe gasket

REMOVAL SERVICE POINTS



<<A>> RIVET REMOVAL


caution Be careful not to damage the heat protector with the drill.

Use a drill (6.0 mm) to make a hole in the rivet to break it, and then remove the rivet.

INSTALLATION SERVICE POINTS



>>A<< RIVET INSTALLATION



Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the parts is fixed in position.