REMOVAL AND INSTALLATION


caution Before removing the clock spring connector, refer to GROUP 52B - SRS Air Bag Service Precautions and Air Bag Module and Clock Spring .
Pre-removal operation
  • Steering column lower cover and side lower panel assembly removal (Refer to GROUP 52A - Instrument Panel Assembly .)
  • Front floor console assembly removal (Refer to GROUP 52A - Floor Console Assembly .)

 Post-installation operation
  • Steering column lower cover and side lower panel assembly installation (Refer to GROUP 52A - Instrument Panel Assembly .)
  • Front floor console assembly installation (Refer to GROUP 52A - Floor Console Assembly .)
  • Key interlock mechanism check (Refer to .)
  • Shift lock mechanism check (Refer to .)
  • Selector lever operation check (Refer to .)




Removal steps

>>B<<
 1.
 Key interlock cable connection (selector lever side)
<<A>>
 >>A<<
 2.
 Key interlock cable connection (steering side)


3.
 Key interlock cable

REMOVAL SERVICE POINTS

<<A>> KEY INTERLOCK CABLE (STEERING SIDE) REMOVAL
Turn the ignition switch to the ACC position and then pull the key interlock cable out from the ignition key cylinder.

INSTALLATION SERVICE POINTS

>>A<< KEY INTERLOCK CABLE (STEERING LOCK CYLINDER SIDE) INSTALLATION
Turn the ignition switch to the ACC position and then install the key interlock cable to the ignition key cylinder.

>>B<< KEY INTERLOCK CABLE INSTALLATION
caution Leave the ignition switch in the LOCK (OFF) position until the key interlock cable installation is completed.
1.Move the selector lever to the P position and turn the ignition switch to the LOCK (OFF) position.

2.Install the tip of the key interlock cable to the lock cam of the selector lever assembly, taking care not to twist the inner cable.
3.Install the adjuster case with its lock guide pulled up (unlocked).
4.Securely push down the lock guide to lock it.
note The lock position of the key interlock cable is automatically adjusted by a spring.