REMOVAL AND INSTALLATION







Front door trim removal steps


·
Tweeter connector

>>B<<
1.
Front door sash trim
<<A>>

2.
Inside handle cover cap
<<B>>

3.
Door trim cap


4.
Front door armrest
<<C>>
>>A<<
5.
Front door trim


6.
Power window switch assembly


7.
Power window switch panel


·
Power window switch connector


8.
Power window switch


9.
Remote-controlled mirror switch (RH)


10.
Inside handle cover


11.
Front door pull handle bracket





Rear door trim removal steps
<<A>>

1.
Inside handle cover cap
<<B>>

2.
Door trim cap


3.
Rear door armrest
<<C>>
>>A<<
4.
Rear door trim


5.
Power window switch assembly


6.
Power window switch panel


7.
Power window switch


8.
Inside handle cover


9.
Rear door armrest bracket

REMOVAL SERVICE POINTS



<<A>> INSIDE HANDLE COVER CAP REMOVAL



Insert a flat-tipped screwdriver as shown in the figure to remove the inside handle cover cap.

<<B>> DOOR TRIM CAP



Insert a flat-tipped screwdriver as shown in the figure to remove the door trim cap.

<<C>> FRONT/REAR DOOR TRIM REMOVAL



Using a flat-tipped screwdriver as shown in the figure, remove the inside lock cable and the inside handle cable, then remove the door trim.

INSTALLATION SERVICE POINTS



>>A<< FRONT DOOR/REAR DOOR TRIM INSTALLATION


After the power window switch is installed or replaced, perform learning of the power window fully-closed position (Refer to GROUP 42A - Door Glass and Regulator ).

>>B<< FRONT DOOR SASH TRIM INSTALLATION



Install it with the clip attached as shown in the figure.