Code No. P0620: Alternator Control Circuit
OPERATION
- When the ignition switch is turned ON, the current should be supplied from the engine-ECU connector terminal ALTL to the alternator connector terminal. When the engine starts under those conditions, the alternator should generate currents. The generated voltage is applied to the engine-ECU connector terminal ALTL from the alternator connector terminal. This allows the engine-ECU to detect that the electrical generation begins.
- The engine-ECU connector terminal ALTG controls the alternator output voltage by turning the power transistor in the unit ON/OFF according to the electrical load.
FUNCTION
- The engine-ECU compares the battery voltage with the voltage generated from the alternator to check whether the electrical generation is normal.
TROUBLE JUDGMENT
Check Conditions
- Ignition switch is "ON" position.
- The engine speed is 600 r/min or more.
- The battery backup voltage is 13.5 V or more.
- The G-terminal duty ratio is 10.2 % or more and 89.8 % or less.
- The FR-terminal duty ratio is 80 % or less and the malfunction of P0622 is not detected.
- For 30 seconds, the final target generation voltage subtracted from the battery backup voltage equals 0.8 V or more.
- For 30 seconds, the battery backup voltage subtracted from the final target generation voltage equals 1.3 V or more.
FAIL-SAFE AND BACKUP FUNCTION
- Prohibits alternator output suppression control against current consumers. (operates as a normal alternator.)
PROBABLE CAUSES
- Failed battery
- Failed drive belt
- Loose connector contact
- Open/short circuit or harness damage in alternator G-terminal circuit
- Open/short circuit or harness damage in alternator L-terminal circuit
- Harness damage in battery backup circuit
- Failed alternator
- Failed engine-ECU
DIAGNOSIS PROCEDURE |
STEP 1. Checking engine start conditions |
|
|
Q.
Have you ever used the booster cable to start the engine?
|
Delete the diagnosis code and check end. |
|
Go to Step 2. |
|
STEP 2. Battery check |
Q.
Is the check result normal?
|
Go to Step 3. |
|
Replace the battery. |
|
STEP 3. Drive belt tension check |
Q.
Is the check result normal?
|
Go to Step 4. |
|
Replace the drive belt. |
|
STEP 4. Check harness between alternator connector terminal and engine-ECU connector terminal ALTG. |
|
Q.
Is the check result normal?
|
Go to Step 5. |
|
Repair or replace the connector, or repair the damaged harness wire. |
|
STEP 5. Check harness between alternator connector terminal and engine-ECU connector terminal ALTL. |
|
Q.
Is the check result normal?
|
Go to Step 6. |
|
Repair or replace the connector, or repair the damaged harness wire. |
|
STEP 6. Check harness between battery and engine-ECU connector terminal BACK. |
|
Q.
Is the check result normal?
|
Go to Step 7. |
|
Repair or replace the connector, or repair the damaged harness wire. |
|
STEP 7. M.U.T.-III diagnosis code |
|
Q.
Is diagnosis code set?
|
Go to Step 8. |
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ). |
|
STEP 8. Replace the drive belt |
|
Q.
Is diagnosis code set?
|
Go to Step 9. |
|
Check end. |
|
STEP 9. Replace the alternator |
|
Q.
Is diagnosis code set?
|
Replace the engine-ECU. |
|
Check end. |
|
Delete the diagnosis code and check end.
