Code No. P0123: Throttle Position Sensor Circuit High Input


OPERATION



  • A power voltage of 5 V is applied to the throttle body assembly connector terminal from the engine-ECU connector terminal TPS5.
  • The power voltage is earthed to the engine-ECU connector terminal TPSE from the throttle body assembly connector terminal.
  • The sensor signal is inputted to the engine-ECU connector terminal TPSM from the throttle body assembly output terminal.

FUNCTION



  • The throttle position sensor converts the throttle valve position into voltage and inputs it into the engine-ECU.
  • The engine-ECU control the throttle valve position.

TROUBLE JUDGMENT


Check Conditions
  • Battery positive voltage is 8 - 16 V
  • 2 seconds later after the ignition switch has been in "ON" position or the engine has started up
Judgment Criterion
  • The throttle position sensor output voltage is 4.85 V or more.

FAIL-SAFE AND BACKUP FUNCTION



  • The throttle valve is opened. (Electrical discontinuity)
  • The DPF regeneration is prohibited.
  • The EGR control is stopped (fully closed).
  • The AS&G control is prohibited.

PROBABLE CAUSES



  • Failed throttle position sensor
  • Open circuit or harness damage in throttle position sensor circuit or loose connector contact
  • Failed engine-ECU

DIAGNOSTIC PROCEDURE

STEP 1. M.U.T.-III data list

  • Refer to Data List Reference Table .

  1. Item 45: Throttle position sensor

Q. Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 2.

STEP 2. Perform resistance measurement at throttle body assembly connector.

  • Disconnect connector, and measure at harness side.
  • Resistance between terminal engine-ECU TPSE line and body earth.
OK: Continuity (2 Ω or less)

Q. Is the check result normal?
Go to Step 5.
Go to Step 3.

STEP 3. Check harness between throttle body assembly connector terminal and engine-ECU connector terminal TPSE.

  • Check earthing line for open circuit and damage.

Q. Is the check result normal?
Go to Step 4.
Repair or replace the connector, or repair the damaged harness wire.

STEP 4. M.U.T.-III data list

  • Refer to Data List Reference Table .

  1. Item 45: Throttle position sensor

Q. Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Replace the engine-ECU.

STEP 5. Replace the throttle body assembly

  • After replacing the throttle body assembly, re-check the trouble symptoms.

Q. Is the check result normal?
Check end.
Replace the engine-ECU.