Inspection Procedure 15: Overheating




COMMENTS ON TROUBLE SYMPTOM



  • The failure could possibly be caused by the failed engine cooling system, defective cooling fan system, faulty engine coolant temperature sensor and so on.

PROBABLE CAUSES



  • Insufficient amount or deteriorated quality engine coolant
  • Failed cooling fan system
  • Failed engine coolant temperature sensor
  • Failed thermostat
  • Failed water pump
  • Failed radiator core
  • Failed engine-ECU

DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III diagnosis code.


Q. Is the diagnosis code set?

Inspection chart for diagnosis code (Refer to ).
Go to Step 2.

STEP 2. Check the radiator fan.



  • Check the radiator fan (Refer to GROUP 14 - Troubleshooting ).

Q. Is the check result normal?

Go to Step 3.
Repair.

STEP 3. Check engine coolant.


note When the engine coolant level is too low, check for any section that cases leakage and repair, if necessary.

  • Check engine coolant (Refer to GROUP 14 - On-vehicle Service - Engine Coolant Leak Check ).

Q. Is the check result normal?

Go to Step 4.
Replace or fill the engine coolant.

STEP 4. M.U.T.-III data list



  • Item 7: Engine coolant temperature sensor
OK:
    Engine cold state: At ambient temperature (atmospheric temperature) or equivalent.
    Engine hot state: At 80 - 120°C

Q. Is the check result normal?

Go to Step 5.
Check engine coolant temperature sensor system (Refer to Code No. P0117 , Refer to Code No. P0118 ).

STEP 5. Check thermostat.



  • Check thermostat (Refer to GROUP 14 - Thermostat and Thermostat Case <4N1> - Thermostat Inspection ).

Q. Is the check result normal?

Go to Step 6.
Replace the thermostat.

STEP 6. Check water pump.



  • Check water pump.

Q. Is the check result normal?

Replace the radiator.
Replace the water pump.