|
|
1.Remove the rear end trim (Refer to GROUP 52A - Interior Trims ).
|

|
2.Replace the striker mounting screws with temporary bolts, and use the remover bar (special
tool: MB990939) and a hammer to tap the temporary bolt to the desired direction. 3.Tighten the striker mounting screws. Tightening torque: 22 ± 3 N·m 4.Install the rear end trim (Refer to GROUP 52A - Interior Trims ).
|

|
1.Loosen the tailgate hinge mounting bolts to adjust the clearance between the tailgate
and body. 2.Tighten the tailgate hinge mounting bolts. Tightening torque: 12 ± 2 N·m
|