Code No.B1134 ECU power supply


caution When replacing the ECU, always check that the communication circuit is normal.

DIAGNOSTIC FUNCTION



JUDGEMENT CRITERIA


Check Conditions
  • After OSS-ECU activation
Judgment Criterion
  • When the following conditions are met, and 1 second or more has elapsed.

  1. +B1 is detected to be ON and +B2 is detected to be OFF.
  2. When +B1 is OFF and +B2 is ON, OSS-ECU detects that the IOD fuse is mounted.

PROBABLE CAUSES



  • Damaged wiring harness or connector (open circuit in +B line)
  • Malfunction of OSS-ECU
  • ETACS-ECU malfunction
note If the IGN fuse (10 A) is blown, there may be a short to earth between the fuse and OSS-ECU or between the fuse and electric steering lock power supply. However, because the IGN fuse is branched off, determine the root cause while referring to the Electrical Wiring Manual.

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III data list
Check the OSS-ECU data list.
Item No.
 Check item
 Normal condition
18
 +B1 Power supply voltage (AD)
 System voltage
19
 +B2 Power supply voltage (AD)
 System voltage
OK: Normal values are displayed for all the items

Q. Is the check result normal?
Normal conditions are displayed for all the items. : Go to Step 4.
Normal condition is not displayed for item No.18 : Go to Step 2.
Normal condition is not displayed for item No.19 : Go to Step 3.

STEP 2. Check of short to power supply, short to earth, and open circuit in +B1 line between OSS-ECU connector and fusible link
note Before the wiring harness check, check the joint connector, ETACS-ECU connector, and repair if necessary.

Q. Is the check result normal?
Go to Step 4.
Repair the connector(s) or wiring harness.

STEP 3. Check of short to power supply, short to earth, and open circuit in +B2 line between OSS-ECU connector and fusible link
note Before the wiring harness check, check the joint connector, ETACS-ECU connector, and repair if necessary.

Q. Is the check result normal?
Go to Step 4.
Repair the connector(s) or wiring harness.

STEP 4. Check whether the diagnosis code is reset.

Q. Is the diagnosis code set?
Replace the OSS-ECU and register the chassis number (Refer to ).
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).