Code No.B16A8 Tail lamp (LH) circuit short <Short circuit in the position lamp (LH) circuit, tail lamp (LH) circuit or the licence plate lamp circuit>



caution
  • Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
  • When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine cannot be started. Register the encrypted code as described in Immobilizer System - How to Register Key ID .)

DIAGNOSTIC FUNCTION




JUDGEMENT CRITERIA




PROBABLE CAUSES



  • Malfunction of bulbs
  • Damaged harness wires and connectors
  • Malfunction of the ETACS-ECU

DIAGNOSIS PROCEDURE


STEP 1. Bulb check



Q. Is the check result normal?





STEP 2. Resistance measurement at the headlamp assembly (position: LH) connector, rear combination lamp (tail: LH) connector, licence plate lamp (LH) connector and licence plate lamp (RH) connector (earth terminals).


(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the resistance between the connector terminal of lamp which does not illuminate and the body earth.

  • Measure the resistance between the headlamp assembly (position: LH) connector (earth terminal) and body earth.
  • Measure the resistance between the rear combination lamp (tail: LH) connector (earth terminal) and body earth.
  • Measure the resistance between the licence plate lamp (LH) connector (earth terminal) and body earth.
  • Measure the resistance between the licence plate lamp (RH) connector (earth terminal) and body earth.
OK: Continuity exists (2 Ω or less)

Q. Is the check result normal?





STEP 3. Check of open circuit in earth lines between the headlamp assembly (position: LH) connector , rear combination lamp (tail: LH) connector, licence plate lamp (LH) connector or licence plate lamp (RH) connector and body earth.


Q. Is the check result normal?





STEP 4. Check of short to power supply, short to earth, and open circuit in (TAL1, TAL2) lines between the headlamp assembly (position: LH) connector , rear combination lamp (tail: LH) connector, licence plate lamp (LH) connector or licence plate lamp (RH) connector and ETACS-ECU connector.


Q. Is the check result normal?





STEP 5. Check whether the diagnosis code is reset.


(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.

Q. Is the diagnosis code set?