Inspection Procedure 3: The system cannot be activated or deactivated even when the sonar switch is pressed.



caution
  • Before replacing the ECU or sensor, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
  • When the illuminated licence plate is installed, the sensors may not operate because of noise from the plate. (When the ultrasonic noise is received, the bass toned buzzer sound continuously. When the ultrasonic noise stops, the normal operation will be resumed immediately.)

COMMENTS ON TROUBLE SYMPTOM




PROBABLE CAUSES



  • Damaged harness wires and connectors
  • Malfunction of sonar switch
  • Malfunction of corner sensor/back sensor-ECU

DIAGNOSIS PROCEDURE


STEP 1. sonar switch check



Q. Is the check result normal?





STEP 2. Resistance measurement at sonar switch connector (earth terminal)


(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the resistance between the sonar switch connector (earth terminal) and body earth.
OK: Continuity exists (2 Ω or less)

Q. Is the check result normal?





STEP 3. Check of open circuit in earth line sonar switch connector and the body earth


Q. Is the check result normal?





STEP 4. Check of short to power supply, short to earth, and open circuit in SW line between sonar switch connector and corner sensor/back sensor-ECU connector


Q. Is the check result normal?