|
When removing the side sill reinforcement outer rear, cut the centre pillar reinforcement
80 mm downward from the installation hole of the rear door hinge because the centre pillar reinforcement
interferes with it. Remove the side sill end plate and the quarter inner front extension lower
as the side sill reinforcement outer rear interferes with them.
|
|
1.When installing the new centre inner pillar parts, remove the centre pillar inner upper
from the centre inner pillar.
|
|
2.When installing the new side sill reinforcement parts, use only the side sill reinforcement
outer rear and the side sill bulkhead A.
3.After installing the side sill reinforcement, install the side sill end plate and
the quarter panel extension front.
|
|
4.When assembling the new front floor side sill outer parts, carry out the following
procedure.
(1)
Machine the body loose panel cushion (MR565301 or MR435765) for replacement as shown and
apply it to the body side because the sound dampening foam material cannot be filled into the
centre pillar.
(2)
Apply body sealant in the area shown in the figure of the front floor side sill outer.
|
