
|
Use special tool water temperature sensor wrench (MB992042) to remove the engine coolant temperature sensor.
|

|
Fit the O-ring to the groove in the cooling water outlet pipe and water pump inlet pipe. Then lubricate the O-ring and the inside of the cooling water outlet hose fitting and water pump assembly with water, and then insert the cooling water outlet pipe and water pump inlet pipe to the cooling water outlet hose fitting and water pump assembly.
|

|
1.Apply the sealant to the thread of the engine coolant temperature sensor. Specified sealant: ThreeBond 1324N or equivalent
| note |
Install the engine coolant temperature sensor immediately after applying sealant.
|
|

|
2.
| caution |
After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area or start the engine.
|
In the same manner as for removal, using special tool water temperature sensor wrench (MB992042), tighten to the specified torque. Tightening torque: 30 ± 9 N·m
|