|
|
1.Remove the drive shaft LH (Refer to  ).
|
|
2.Use special tool rear axle shaft oil seal remover (MB990590) to remove the oil seal.
|
|
3.Use the following special tools to install new oil seal.
- Bearing and oil seal installer set (MB990934)
- Bearing and oil seal installer set (MB990938)
|
|
4.
| caution |
- Be careful not damage the lip of oil seal.
- Replace the circlip attached to the spline of LH DOJ side of driveshaft with a new one.
|
Apply multipurpose grease to the oil seal to lip before installing the drive shaft LH (Refer to ).
|