|
Check the wiper motor with the motor installed to the vehicle and the harness connector disconnected.
|
|
|
Connect the battery to the rear wiper motor as shown in the illustration, and then check the operation of the wiper motor.
|
|
|
- Operate the wiper motor by the same method as described in the check procedure above. Then, while the motor is operating, disconnect the battery to make the wiper motor stop.
- Reconnect the battery as shown in the illustration, and then check whether the wiper motor automatically stops in the correct stop position after it has been running.
|
|
Check continuity between the switch terminals.
|
|
Switch position
|
Tester connection
|
Specified condition
|
OFF
|
4 - 6, 5 - 6
|
Open circuit
|
Rear wiper switch
|
4 - 6
|
Continuity (Less than 2 Ω)
|
Rear washer switch
|
5 - 6
|
|
|
