INSPECTION PROCEDURE 8: The rain sensitive wiper function works even though these is no rainfall. <Vehicles with lighting control sensor>


caution Whenever ECU is replaced, ensure that the input and output signal circuits are normal.






COMMENTS ON TROUBLE SYMPTOM
The lighting control sensor, the harness connector, or the ETACS-ECU may be defective.

PROBABLE CAUSES

  • Malfunction of the lighting control sensor
  • Malfunction of ETACS-ECU
  • Damaged wiring harness and connectors
  • Malfunction of CAN converter-ECU
  • Malfunction of FRONT-ECU

DIAGNOSTIC PROCEDURE

STEP 1. Lighting control sensor installation surface check
Visually check the presence of scratches or air bubbles (diameter of 5 mm or more) on the windshield to which the lighting control sensor is installed.

Q. Is the check result normal?
Go to Step 2.
Replace the windshield (Refer to GROUP 42 - Windshield Removal and Installation ).

STEP 2. Windshield wiper operation check
Check that the windshield wipers work normally.

Q. Is the check result normal?
Go to Step 3.
Refer to Inspection procedure 3 .

STEP 3. M.U.T.-III diagnosis code
Check if CAN converter-ECU-related diagnosis code is set.

Q. Is the diagnosis code set?
Diagnose the CAN converter-ECU. Refer to GROUP 54A - Headlamp Diagnosis Code Chart .
Go to Step 4.

STEP 4. M.U.T.-III diagnosis code
Check if a lighting control sensor diagnosis code is set.

Q. Is the diagnosis code set?
Diagnose the lighting control sensor. (Refer to GROUP 54A - Diagnosis Code Chart .)
Go to Step 5.

STEP 5. M.U.T.-III diagnosis code
Check if an ETACS-related diagnosis code is set.

Q. Is the diagnosis code set?
Diagnose the ETACS-ECU. Refer to GROUP 54A - ETACS .
Go to Step 6.

STEP 6. Connector check: D-252 CAN converter-ECU connector

Q. Is the check result normal?
Go to Step 7.
Repair the damaged connector.

STEP 7. Measure the voltage at the D-252 CAN converter-ECU connector.
(1)Disconnect the connector, and measure the voltage at the wiring harness side.
(2)Measure the voltage between D-252 CAN converter-ECU connector terminal No. 12 and body earth.
OK: System voltage

Q. Is the check result normal?
Replace the Lighting control sensor.
Go to Step 8.

STEP 8. Check the wiring harness between D-252 CAN converter-ECU connector terminal No.12 and E-136 lighting control sensor connector terminal No.3.

  • Check the input and output lines for open or short circuit.

Q. Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)
Repair the wiring harness.