INSPECTION
AIR BAG MODULE CHECK |
1.Check the pad cover for dents, cracks or deformation. 2.Check the connectors for damage, the terminals for deformation, and the harness for binds. 3.Check the air bag inflator case for dents, cracks or deformation. 4.Install the driver’s air bag module to the steering wheel and check fit and alignment with the wheel. 5.Install the passenger’s (front) air bag module to the instrument panel and front deck crossmember and check fit and alignment. |
CLOCK SPRING CHECK |
If any malfunction is found in the following inspections, replace the clock spring with a new one. |
1.Check the connectors and protective tubes for damage and the terminal for deformation. 2.Check the case for damage. 3.Check that the continuity exists between the following connector terminals.
|
4.
5. Connect the circuit tester to the special tool extra fine probe (MB992006) as shown in the figure and check the continuity among terminal No.1 and 2 or terminal No.3 and 4. |