|
|
It is suspected that the power supply circuit to the ETACS-ECU is defective, or the wiring harness between the diagnosis connector and the ETACS-ECU or their connector(s) is damaged.
|
|
|
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
|
|
Use the M.U.T.-III to confirm that it communicates with the engine-ECU.
|
|
|
Q.
Is the check result normal?
|
|
|
Diagnose the system, which cannot communicate with the M.U.T.-III.
|
|
|
|
|
|
When the ignition switch is turned ON, check if the M.U.T.-III can communicate with the system.
|
|
|
Q.
Is the check result normal?
|
|
|
Refer to inspection procedure A-1 "Check the battery power supply circuit to the ETACS-ECU ."
|
|
|
|
|
|
Q.
Is the check result normal?
|
|
|
Repair the defective connector.
|
|
|
|
|
|
(1)Remove the ETACS-ECU, and measure at the junction block side.
|
|
|
(2)Resistance between ETACS-ECU connector terminal No.3 and body earth OK: Continuity exists (2 Ω or less)
|
|
|
(3)Disconnect the D-420 ETACS-ECU connector, and measure at the wiring harness side.
|
|
|
(4)Resistance between D-420 ETACS-ECU connector terminal No.56 and body earth OK: Continuity exists (2 Ω or less)
|
|
|
Q.
Is the check result normal?
|
|
|
- Check the earth wires for open circuit.
|
|
|
Q.
Are the check results normal?
|
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
|
|
|
|
|
|
Repair the wiring harness.
|
|
|
|
|
|
Q.
Is the check result normal?
|
|
|
Repair the defective connector.
|
|
|
|
|
|
- Check the communication lines for open and short circuit.
|
|
|
Q.
Are the check results normal?
|
|
|
Repair the wiring harness.
|
|
|
|
|
|
Check whether the communication with the M.U.T.-III is possible.
|
|
|
Q.
Is the check result normal?
|
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
|
|
|
|