|
|
1.Remove the cruise control switch (Refer to  ).
|
|
2.Measure the resistance between terminal No.3 and terminal No.4 when each of the "ON/OFF",
"CANCEL", "COAST/SET" and "ACC/RES" switches is pushed. If the values measured
at the time each switch is pushed correspond to those in the table below, the resistance values are
correct.
|
|
Terminal connector of tester
|
Switch position
|
Specified condition
|
3 - 4
|
All switches are released.
|
Open circuit
|
"ON/OFF" switch is pushed
|
Continuity (less than 2 ohms)
|
"CANCEL" switch is pushed
|
202.5 - 208 Ω
|
"COAST/SET" switch is pushed
|
610.5 - 624.5 Ω
|
"ACC/RES" switch is pushed
|
1838 - 1877 Ω
|
|
3.Check that illumination of the cruise control switch illumination lamp turns on when
the battery positive terminal is connected to cruise control switch connector terminal No.2,
and the battery negative terminal is connected to cruise control switch connector terminal No.1.
|
|
|
Refer to GROUP 35A - Brake Pedal, Inspection, Stop Lamp Switch Check .
|
|
|
Refer to GROUP 21A - On-vehicle Service, Clutch Switch Continuity Check .
|
|
|
Refer to GROUP 23A - On-vehicle Service, Essential Service, Inhibitor Switch
Continuity Check . <6G7>
|
|
|
Refer to GROUP 23C - On-vehicle Service, Essential Service, Inhibitor Switch
Continuity Check . <4M4>
|
|
|
Refer to GROUP 13A - On-vehicle Service, Throttle Valve Control Servo Check <6G75>.
|
|
|
Refer to GROUP 13D - On-vehicle Service, Throttle Valve Control Servo Check <6G72>.
|