|
|
1.Move the selector lever to the N position.
|
|
|
2.Loosen the adjusting nut, and set the manual control lever upper and lower to the
free condition.
|
|
|
3.Move the manual control lever lower to the neutral position.
|
|
4.Align the hole at the end of the manual control lever lower and the hole in the inhibitor
switch flange (section A - A in the illustration at left).
| note |
The inhibitor switch can be aligned by inserting a 5-mm bar in the holes of the manual
control lever end and the inhibitor switch flange.
|
|
|
5.Gently push the transmission control cable in the direction as shown in the illustration
at left, and tighten the adjusting nut the specified torque.
Tightening torque: 23 ± 4 N·m
6.Check that the selector lever is at the N position.
7.Check that the transmission shifts to the correct range corresponding to the position
of the selector lever, and that it functions correctly in that range.
|